Use this bar to show information about your cookie policy.
Description
Hose Barb Plug
This is a plug for the PSS Shaft Seal hose barb. If your boat will not exceed 10 knots under power, then the PSS Shaft Seal does not require positive water feed. The PSS Shaft Seal can simply be "vented", or you can use this plug-in in place of the hose barb that's inserted into the carbon stator.
"Burping" the PSS Shaft Seal
You will also be required to "burp" the PSS Shaft Seal whenever there is air trapped inside. Simply pull back on the carbon stator, separating it from the stainless-steel rotor. This will cause a quick mist of water to spray out.
Important
If your boat will exceed 10 knots under power, then it is required that a positive water supply be plumbed to the PSS Shaft Seal for the purpose of lubricating and cooling the seal faces.
So much better than the rubber ones I took off, easy install!
Spreader Boots
Daz Jensen
Where Have You Been All My Boating Life?
What a great little piece of tech - I don't know how we got by without it in the past. No more guessing how full the holding tank is or having to clean icky tank senders. This little bluetooth RADAR sending unit mounts on top of the tank and connects wirelessly to our Victron Cerbo.
Setup is super easy, push the button on the unit so it can calibrate to the tank then enable bluetooth and set up your rank dimensions on your Cerbo. It's as easy as that.
We've had it installed and running for about two weeks now and couldn't be more pleased (We like it enough that I ordered a second one for our water tank.)
Lots of wiring - no leaks! Be sure to run ALL the wires through BEFORE completing the run!
Seaview White Plastic Vertical Cable Seal f/Multiple Wires Up to 10.6mm/0.5"
Ari Storch
"Currently" super happy.
Installed on Yanmar 4JH57 engines with Zeus Controllers - HOLY WOW power. Losing some power at top end but overall very satisfied. Will do a long term review later. Talk about power - hope to never need my generator again!
