ProSport 1.5 Amp fully automatic maintainer is an innovative multi-use charger designed for maximum utility. Concealed mounting holes allow the ProSport 1.5 to be installed on-board or to be used as a portable, with rear die cut foam resting pad. Ring terminal and DC clamp quick connect cable assemblies included. Our marine grade design is weatherproof, water resistant to IP 65 and can be used in all fresh and salt water outdoor and indoor applications as needed. Designed to keep 12V batteries fully charged during short or long term storage periods, ProSport's Energy Saver mode will monitor and auto maintain a battery when needed to maintain a full state of charge. ProSport 1.5 significantly reduces AC Power consumption, lowers operating costs and maximizes reserve power performance.
Features:
Fully automatic energy saving design
Multi-use design, easily configures for on-board or portable use
Concealed mounting holes & die cut foam resting pad for portable use
Expanded LED display for Power, Charging and Auto Maintain status
Maintain 12V lead acid (sealed & vented) batteries up to 150A hours
Quick connect DC clamp & ring terminal cable assemblies
Weatherproof and water resistant to IP65
Built-in safety with reverse polarity, short circuit, temperature and ignition protection
Pre-wired for easy installation
3 year warranty
Meets UL 1236 and CSA Standards, cETLus
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
So much better than the rubber ones I took off, easy install!
Spreader Boots
Daz Jensen
Where Have You Been All My Boating Life?
What a great little piece of tech - I don't know how we got by without it in the past. No more guessing how full the holding tank is or having to clean icky tank senders. This little bluetooth RADAR sending unit mounts on top of the tank and connects wirelessly to our Victron Cerbo.
Setup is super easy, push the button on the unit so it can calibrate to the tank then enable bluetooth and set up your rank dimensions on your Cerbo. It's as easy as that.
We've had it installed and running for about two weeks now and couldn't be more pleased (We like it enough that I ordered a second one for our water tank.)
Lots of wiring - no leaks! Be sure to run ALL the wires through BEFORE completing the run!
Seaview White Plastic Vertical Cable Seal f/Multiple Wires Up to 10.6mm/0.5"
Ari Storch
"Currently" super happy.
Installed on Yanmar 4JH57 engines with Zeus Controllers - HOLY WOW power. Losing some power at top end but overall very satisfied. Will do a long term review later. Talk about power - hope to never need my generator again!