The DeckHand 25 has a 25-lb anchor capacity (anchor not included). Includes davit for stowing most styles of anchors. Pre-spooled with 60 feet of 800-lb test nylon rope. Runs on 12-volt battery (not included). Get precision boat placement and the ability to stay on the fish as long as you want with a DeckHand electric anchor winch. It automatically raises or lowers your anchor at the touch of a button, and its special anti-drag system senses the bottom to allow for controlled drifting.
Features
25-lb anchor capacity (anchor not included)
Pre-spooled with 60 feet of 800-lb test nylon rope
Davit can be mounted at base of DeckHand or in remote position on deck
Davit stows most kinds of anchors
Stow and deploy switch integrated into the base of the unit
Auto-drift feature automatically stops the motor when the anchor touches bottom (or hits an obstacle); when slack in teh rope becomes tight, rope is automatically released; lock the winch with the touch of a button
Consistent hold pattern with older DeckHand models (DH-18, DH-20, DH-35)
Includes: remote mountable anchor davit
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
No issues with install and regulator installation.
At first has some rpm reading issue but it was easily fixed by tweaking min duty setting thanks to the support team at yacht rigger.
Installed with an APS alternator.
ARCO Zeus Alternator Regulator- Standard
Tom in Oxford
Lugs .... but more
While the review is for lugs, its actually for a lot more than that. I upgraded from AMGs to new lithium batteries. I bought these 4/0 lugs but also the 4/0 cables, fuses, cable shrink wrap and more. Basically everything I needed for the project. A huge shout out to the Yacht Rigger as being a DYI'er there were bits and pieces I needed last minute that got shipped right away and then a few items that I swapped out. They made this super easy.
Ancor 90 Tinned Copper Lug #4/0 - 3/8" - 2-Piece
Tom in Oxford
Arco Zeus alternator regulator
After a lot of research, bought two of these units to go along with new Balmer XT-CR-170 alternators. Installation was a challenge but only due to having to run wires from one side of boat to the other but the support from Yacht Rigger electrical department was stellar. I had a couple of calls with Mike and he walked me through setup and configuration.
ARCO Zeus Alternator Regulator- Extended
Adam Green
Nice product for sealing cable routes on my boat
Using this for a Starlink install. Looks to be easy to use and effective in keeping water out of the hole for the cable.
Super high quality products! Easy to install with the easy-to-follow instructions and expert guidance from The Yacht Rigger. (Be sure to turn the shore power off and unplug the cord!)