Use this bar to show information about your cookie policy.
Description
Electric Hatch Lift- 12-Volt
Stroke: 24"
L.O.A Retracted: 37" L.O.A. Extended: 61"
12 and 24-Volt with 2 foot leads and deutsch connectors. Inline motor design delivers over 500 pounds of force. Includes high impact, corrosion proof mounting brackets and stainless steel pull pins.
Features:
Clear anodized aluminum tubing
Complete with 2 foot lead and Deutsch plug
Clutchless ball screw design will not drift- never binds and runs in sync on dual lift applications
Inline motor design delivers over 500 pounds of force
Water resistant and made entirely of non-corrosive materials
Ball screw spins freely when hatch is fully opened or closed eliminating limit switches and burned out motors
High impact, corrosion proof mounting brackets with stainless steel pull pins
Powdered metal gears for strength and precision
Stainless steel ram locks in any position
CE-certified, ignition protected and ABYC compliant
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.
No issues with install and regulator installation.
At first has some rpm reading issue but it was easily fixed by tweaking min duty setting thanks to the support team at yacht rigger.
Installed with an APS alternator.
ARCO Zeus Alternator Regulator- Standard
Tom in Oxford
Lugs .... but more
While the review is for lugs, its actually for a lot more than that. I upgraded from AMGs to new lithium batteries. I bought these 4/0 lugs but also the 4/0 cables, fuses, cable shrink wrap and more. Basically everything I needed for the project. A huge shout out to the Yacht Rigger as being a DYI'er there were bits and pieces I needed last minute that got shipped right away and then a few items that I swapped out. They made this super easy.
Ancor 90 Tinned Copper Lug #4/0 - 3/8" - 2-Piece
Tom in Oxford
Arco Zeus alternator regulator
After a lot of research, bought two of these units to go along with new Balmer XT-CR-170 alternators. Installation was a challenge but only due to having to run wires from one side of boat to the other but the support from Yacht Rigger electrical department was stellar. I had a couple of calls with Mike and he walked me through setup and configuration.
ARCO Zeus Alternator Regulator- Extended
Adam Green
Nice product for sealing cable routes on my boat
Using this for a Starlink install. Looks to be easy to use and effective in keeping water out of the hole for the cable.
Super high quality products! Easy to install with the easy-to-follow instructions and expert guidance from The Yacht Rigger. (Be sure to turn the shore power off and unplug the cord!)
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
