Use this bar to show information about your cookie policy.
Description
Take good care of the cooling system - change to a new impeller every year!
The impeller is a very important security device. Its task is to pump the water through the cooling system of the engine. But remember that the impeller should be replaced every year. And always make sure you get a Johnson Pump Brand original impeller. Then you'll know it matches your pump exactly.
50,8 mm Width 22mm Impeller article number 09-1026B Neoprene (for cooling) Replaces Jabsco 673-0001 Europe & USA
While the review is for lugs, its actually for a lot more than that. I upgraded from AMGs to new lithium batteries. I bought these 4/0 lugs but also the 4/0 cables, fuses, cable shrink wrap and more. Basically everything I needed for the project. A huge shout out to the Yacht Rigger as being a DYI'er there were bits and pieces I needed last minute that got shipped right away and then a few items that I swapped out. They made this super easy.
Ancor 90 Tinned Copper Lug #4/0 - 3/8" - 2-Piece
Tom in Oxford
Arco Zeus alternator regulator
After a lot of research, bought two of these units to go along with new Balmer XT-CR-170 alternators. Installation was a challenge but only due to having to run wires from one side of boat to the other but the support from Yacht Rigger electrical department was stellar. I had a couple of calls with Mike and he walked me through setup and configuration.
ARCO Zeus Alternator Regulator- Extended
Adam Green
Nice product for sealing cable routes on my boat
Using this for a Starlink install. Looks to be easy to use and effective in keeping water out of the hole for the cable.
Super high quality products! Easy to install with the easy-to-follow instructions and expert guidance from The Yacht Rigger. (Be sure to turn the shore power off and unplug the cord!)
SmartPlug 50 AMP Stainless Steel Combo Kit
Jay P
Great, but
A great , well made, product. Unfortunately, for the average piece of electronics, there is not enough room for the number and size of wire and connectors to pass thru the case into the rail. Photo of blank instrument panel and mount.
