Use this bar to show information about your cookie policy.
Description
Thru-Hull Installation Tool
Thru Hull Installation Tool
The Concept:
THT-530 makes the installation of standard GROCO thru-hull fittings possible by a single installer. Slide the thru-hull fitting, flanged end first, over the tool. (It will stop at the proper step.) Tie a length of monofilament to the eye and place it into the already-cut hole in the hull of the boat. Apply caulking to the flange of the fitting, and pull the fitting through the hole and against the hull from inside the boat. Thread the mono-filament through the locknut or seacock. With the fitting pulled firmly against the hull the locknut or the seacock may be screwed onto the fitting.
THT-530 fits GROCO Thru-hull Fitting Sizes from 1/2" through 3"
So much better than the rubber ones I took off, easy install!
Spreader Boots
Daz Jensen
Where Have You Been All My Boating Life?
What a great little piece of tech - I don't know how we got by without it in the past. No more guessing how full the holding tank is or having to clean icky tank senders. This little bluetooth RADAR sending unit mounts on top of the tank and connects wirelessly to our Victron Cerbo.
Setup is super easy, push the button on the unit so it can calibrate to the tank then enable bluetooth and set up your rank dimensions on your Cerbo. It's as easy as that.
We've had it installed and running for about two weeks now and couldn't be more pleased (We like it enough that I ordered a second one for our water tank.)
Lots of wiring - no leaks! Be sure to run ALL the wires through BEFORE completing the run!
Seaview White Plastic Vertical Cable Seal f/Multiple Wires Up to 10.6mm/0.5"
Ari Storch
"Currently" super happy.
Installed on Yanmar 4JH57 engines with Zeus Controllers - HOLY WOW power. Losing some power at top end but overall very satisfied. Will do a long term review later. Talk about power - hope to never need my generator again!
