Use this bar to show information about your cookie policy.
Description
4' Cellular Antennas 9dB Gain, Dual Band
Digital Antenna's dual band cellular antennas improve signals on cellular (824-894 MHz) and PCS (1850-1990 MHz) bands. They are omni-directional, transmitting and receiving signals from all directions, which provides you with 10 times the signal strength of a cell phone used by itself.
With a powerful 9dB gain and professional marine grade construction, these 4' cellular antennas deliver high performance that will last for years. Each antenna is designed for easy connection to your cell phone or amplifier.
All of our antennas are made in the USA, assembled, tested and tuned by hand for maximum performance, quality and durability.
All 4' Dual Band Cellular Antennas Feature:
Powerful brass radiators
Soldered connections
Power directing ferrite choke bead
High gloss urethane finish
316 stainless steel ferrule
9dB gain
800 Series:
Mount: Stainless steel double female ferrule for mounting 1"14 threaded base
Connector: Highest quality type N female
Cable: Not included use our PowerMax low loss antenna cable
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.
No issues with install and regulator installation.
At first has some rpm reading issue but it was easily fixed by tweaking min duty setting thanks to the support team at yacht rigger.
Installed with an APS alternator.
ARCO Zeus Alternator Regulator- Standard
Tom in Oxford
Lugs .... but more
While the review is for lugs, its actually for a lot more than that. I upgraded from AMGs to new lithium batteries. I bought these 4/0 lugs but also the 4/0 cables, fuses, cable shrink wrap and more. Basically everything I needed for the project. A huge shout out to the Yacht Rigger as being a DYI'er there were bits and pieces I needed last minute that got shipped right away and then a few items that I swapped out. They made this super easy.
Ancor 90 Tinned Copper Lug #4/0 - 3/8" - 2-Piece
Tom in Oxford
Arco Zeus alternator regulator
After a lot of research, bought two of these units to go along with new Balmer XT-CR-170 alternators. Installation was a challenge but only due to having to run wires from one side of boat to the other but the support from Yacht Rigger electrical department was stellar. I had a couple of calls with Mike and he walked me through setup and configuration.
ARCO Zeus Alternator Regulator- Extended
Adam Green
Nice product for sealing cable routes on my boat
Using this for a Starlink install. Looks to be easy to use and effective in keeping water out of the hole for the cable.
Super high quality products! Easy to install with the easy-to-follow instructions and expert guidance from The Yacht Rigger. (Be sure to turn the shore power off and unplug the cord!)