Ignition protected - safe for installation aboard gasoline powered boats
Activated by an ON-OFF switch mounted anywhere
Integrated coil control minimizes heating and amperage draw
450 Amp Class
Designed for 12 or 24 Volt systems
Ignition protected -- safe for installation aboard gasoline-powered boats
Activated by a low amperage ON-OFF switch mounted anywhere
Specifications:
Control Circuit Connection: 20 AWG Tinned Wire
Nominal Voltage: 12V DC / 24V DC
Coil Function: Normally Open
Mounting: #10
Operating Amperage Current: 3.6A when changing state
Amperage Operating Current: 0.13A @ 12 V / 0.07A @ 24 V
Terminal Stud Torque: 90 in-lb (10.17 Nm)
Continuous Rating: 250A Using 1/0 Wire Size / 300A Using 2/0 Wire Size / 400A Using 4/0 Wire Size / 450A Using 2 x (2/0) Wire Size
Intermittent Rating: 275A (5 min) Using 1/0 Wire Size / 400A (5 min) Using 2/0 Wire Size / 500A (5 min) Using 4/0 Wire Size / 600A (5 min) Using 2 x (2/0) Wire Size
Cranking Rating 30 sec: 1,000A / 1000A DC
Contact Form: SPST-NO
Input Voltage: 9-36V DC
Inrush Rating: 0.25 sec (10 repeats): 2000A
Switching Cycles: 1,000,000
Terminal Stud: Serrated Flange Nut
Terminal Stud Length: 0.66" (16.76mm)
Terminal Stud Size: 5/16" (M8)
Weight: 1.00lb (0.45 kg)
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
No issues with install and regulator installation.
At first has some rpm reading issue but it was easily fixed by tweaking min duty setting thanks to the support team at yacht rigger.
Installed with an APS alternator.
ARCO Zeus Alternator Regulator- Standard
Tom in Oxford
Lugs .... but more
While the review is for lugs, its actually for a lot more than that. I upgraded from AMGs to new lithium batteries. I bought these 4/0 lugs but also the 4/0 cables, fuses, cable shrink wrap and more. Basically everything I needed for the project. A huge shout out to the Yacht Rigger as being a DYI'er there were bits and pieces I needed last minute that got shipped right away and then a few items that I swapped out. They made this super easy.
Ancor 90 Tinned Copper Lug #4/0 - 3/8" - 2-Piece
Tom in Oxford
Arco Zeus alternator regulator
After a lot of research, bought two of these units to go along with new Balmer XT-CR-170 alternators. Installation was a challenge but only due to having to run wires from one side of boat to the other but the support from Yacht Rigger electrical department was stellar. I had a couple of calls with Mike and he walked me through setup and configuration.
ARCO Zeus Alternator Regulator- Extended
Adam Green
Nice product for sealing cable routes on my boat
Using this for a Starlink install. Looks to be easy to use and effective in keeping water out of the hole for the cable.
Super high quality products! Easy to install with the easy-to-follow instructions and expert guidance from The Yacht Rigger. (Be sure to turn the shore power off and unplug the cord!)