187 - Series Thermal Circuit Breakers - Panel Mount
70 Amp Circuit Breaker
PN: 7041
Features:
Combines switching and circuit protection into a single device
All components meet SAE J1171 external ignition protection requirements
Clear, single lever operation
"Trip Free" design cannot be held "ON" during fault current condition
Waterproof
Recessed mounting holes for clean appearance
Self-trimming case eliminates the need for mounting panels or trim bezels
Round case permits easy installation with standard sized hole saw
Large clearance around terminal studs accept heavy gauge wire lugs
Robust 5/16 terminals provide high torque connections
Large lever with vertical/horizontal orientation provides indication of trip status
Ignition protected - safe for installation aboard gasoline powered boats
Specifications
Circuit Breaker Class:
Type III - Switchable / Manual Reset - Trip Free
Type:
Thermally Responsive Bi-Metal Blade
Case Material:
Thermoset Polyester
Voltage Rating:
48 Volts DC Maximum
Interrupt Rating:
5,000 Amperes @12 Volts DC
3,000 Amperes @24 Volts DC
1,500 Amperes @42 Volts DC
Operating Temperature Range:
-25C° to +82C°
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
The Z Bar Class T Fuse Holder solves a real problem, and does so in a simple and affordable way.
Z Bar - Class T battery link Bundle
Jerome
Installed regulator on a beneteau 45
No issues with install and regulator installation.
At first has some rpm reading issue but it was easily fixed by tweaking min duty setting thanks to the support team at yacht rigger.
Installed with an APS alternator.
ARCO Zeus Alternator Regulator- Standard
Tom in Oxford
Lugs .... but more
While the review is for lugs, its actually for a lot more than that. I upgraded from AMGs to new lithium batteries. I bought these 4/0 lugs but also the 4/0 cables, fuses, cable shrink wrap and more. Basically everything I needed for the project. A huge shout out to the Yacht Rigger as being a DYI'er there were bits and pieces I needed last minute that got shipped right away and then a few items that I swapped out. They made this super easy.
Ancor 90 Tinned Copper Lug #4/0 - 3/8" - 2-Piece
Tom in Oxford
Arco Zeus alternator regulator
After a lot of research, bought two of these units to go along with new Balmer XT-CR-170 alternators. Installation was a challenge but only due to having to run wires from one side of boat to the other but the support from Yacht Rigger electrical department was stellar. I had a couple of calls with Mike and he walked me through setup and configuration.
ARCO Zeus Alternator Regulator- Extended
Adam Green
Nice product for sealing cable routes on my boat
Using this for a Starlink install. Looks to be easy to use and effective in keeping water out of the hole for the cable.
Blue Sea 1003 CableClam 1.39"
Help
Live Help!! No chatbot👋🏻
Hi ,Welcome to The Yacht Rigger
We have ABYC techs and boating experts standing by. Look for the green dot below to see if someone is online. If not we will get back to you as soon as we can.