The MD range of battery switches allow you to install the battery switch very close to the battery, to remotely manage the increased electrical loads found on today's boats. This reduces cable lengths and sizes, providing significant savings in expense and weight of copper battery cable. They are ideal for remote isolation of bow and stern thrusters. The 720-MDO has been enhanced to offer easy standard installation, or advanced options capable of switching different voltage circuits from the main supply (for example: a 48 volt bow thruster with a 24 volt house supply). The optical sensor uses the same easy connection for standard installation and gives you the ability to control different voltage circuits such as 36 or 48 volts. It can be used to switch positive or negative lines and the main contacts can be isolated from the control circuit allowing operation via another battery source. This optical sensor also has low stand-by current draw (<5mA).
Remote operation
Battery switch can be mounted alongside battery, reducing cable lengths and cable sizes. (Large cost and weight saving in copper cables)
Reduced installation labor due to shorter battery cable runs
Manual override option to meet CE/ABYC requirements
LED status identification for remote control switch
Same capacities/specifications and mounting options as standard BEP battery switches
Uses interchangeable labeling system (Item # 713 or 715)
Specifications: LxWxH: 4" x 4" x 4.33" Rating (A DC) Cont: 500 Rating (A DC) Inter: 700 Rating (A DC) Crank: 2500 Voltage (V DC): 9.5-32 Function: On/Off Stud Size: 2x (1/2"/12mm)
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
So much better than the rubber ones I took off, easy install!
Spreader Boots
Daz Jensen
Where Have You Been All My Boating Life?
What a great little piece of tech - I don't know how we got by without it in the past. No more guessing how full the holding tank is or having to clean icky tank senders. This little bluetooth RADAR sending unit mounts on top of the tank and connects wirelessly to our Victron Cerbo.
Setup is super easy, push the button on the unit so it can calibrate to the tank then enable bluetooth and set up your rank dimensions on your Cerbo. It's as easy as that.
We've had it installed and running for about two weeks now and couldn't be more pleased (We like it enough that I ordered a second one for our water tank.)
Lots of wiring - no leaks! Be sure to run ALL the wires through BEFORE completing the run!
Seaview White Plastic Vertical Cable Seal f/Multiple Wires Up to 10.6mm/0.5"
Ari Storch
"Currently" super happy.
Installed on Yanmar 4JH57 engines with Zeus Controllers - HOLY WOW power. Losing some power at top end but overall very satisfied. Will do a long term review later. Talk about power - hope to never need my generator again!
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
