Use this bar to show information about your cookie policy.
Description
Mix & Match Cable for Raymarine 600W Non-CHIRP Transducers
Mix and Match 600W transducers are made as a common base transducer with a short (2m) cable attached, plus an interchangeable longer (8m) brand-specific adapter cable. The short pigtail attached to the transducer ends in an Airmar 5-pin male connector. The adapter cables have a matching Airmar 5-pin female connector at one end and the correct connector for a specific electronics brand at the other end.
Both parts are needed for installation. If the user changes equipment brand later, the transducer can be left in place and the adapter cable replaced.
*600W Mix and Match cables cannot be used with 1kw transducers or CHIRP transducers.
So much better than the rubber ones I took off, easy install!
Spreader Boots
Daz Jensen
Where Have You Been All My Boating Life?
What a great little piece of tech - I don't know how we got by without it in the past. No more guessing how full the holding tank is or having to clean icky tank senders. This little bluetooth RADAR sending unit mounts on top of the tank and connects wirelessly to our Victron Cerbo.
Setup is super easy, push the button on the unit so it can calibrate to the tank then enable bluetooth and set up your rank dimensions on your Cerbo. It's as easy as that.
We've had it installed and running for about two weeks now and couldn't be more pleased (We like it enough that I ordered a second one for our water tank.)
